Wire a removable terminal block (rtb) – Rockwell Automation 1756-HYD02 ControlLogix Hydraulic Servo Module User Manual
Page 8
Advertising
8 ControlLogix™ Hydraulic Servo Module
Publication
1756-IN580A-EN-P - March 2003
Wire a Removable Terminal Block (RTB)
Your 1756-HYD02 module uses two types of RTBs (each RTB comes
with housing) to connect wiring.
· Cage clamp - Catalog number 1756-TBCH
· Spring clamp - Catalog number 1756-TBS6H
Connect the wires as shown below.
Spring Clamp RTB
Cage Clamp RTB
20860-M
20859-M
1. Strip 7/16 inch (11mm) maximum
length of wire.
2. Insert the screwdriver into the
inner hole of the RTB.
3. Insert the wire into the
open terminal and
remove the screwdriver.
1. Strip 3/8 inch (9.5mm) maximum
length of wire.
2. Insert the wire into the open terminal.
3. Turn the screw clockwise to close the
terminal on the wire.
Advertising