Rockwell Automation 1756-HYD02 ControlLogix Hydraulic Servo Module - Manual (Page 9)

ControlLogix™ Hydraulic Servo Module 9
Publication 1756-IN580A-EN-P - March 2003
Wire to a Servo Module
Use the wiring example in Figure 1 to wire to your module.
Figure 1
+OUT-0
-OUT-0
+ENABLE-0
-ENABLE-0
DRVFLT-0
CHASSIS
IN_COM
HOME-0
REG24V-0
REG5V-0
+OK
CHASSIS
+INT-0
-INT-0
+RET-0
-RET-0
LDT CMN
CHASSIS
+OUT-1
-OUT-1
+ENABLE-1
-ENABLE-1
DRVFLT-1
CHASSIS
IN_COM
HOME-1
REG24V-1
REG5V-1
-OK
CHASSIS
+INT-1
-INT-1
+RET-1
-RET-1
LDT CMN
CHASSIS
General cable
C0720
To valve
To home
limit
switch
To E-stop relay coil
To valve or pump
To Linear
Displacement
Transducer
(LDT)
To
registration
sensor
1. This is a general wiring example illustrating Axis 1 wiring only. Other
configurations are possible with Axis wiring identical to Axis 1.
2. Make sure that any transducer connected to the 1756-HYD02 module
uses an external interrogation signal.
3. Do not exceed the specified isolation voltage between power sources.
NOTES:
43394
General cable
C0721
General cable
C0720
General cable
C0720
General cable
C0722
General cable
C0720