Rockwell Automation 1794-OF8IH FLEX I/0 8 Isolated Output Analog Module - Manual (Page 15)

FLEX I/O Isolated Output HART Analog Module 15
Publication 1794-IN120C-EN-P - April 2009
16 Channel 7 Analog Fault Value Output Data
17 Reserved C
7 C
6 C
5 C
4 C
3 C
2 C
1 C
0
Note: Reserved data may not be shown in certain controller software
(1)
not shown or used in RSLogix 5000.
Configuration Map descriptions
BOA
BOB
Byte order group A
Byte order group B
Byte order group A and B values must match each
other. Refer to the Byte Order table
FT LocalFaultMode 0: Outputs set to safe
value on communication
faults only 1: Outputs set to safe
value on any fault
EWn Fault Enable for wire fault
detection on channel n.
(1)
0: Disable wire off/lead
break detection 1: Enable wire off/lead
break detection
(2)
CHn
HART
Current
Ratio HART current fault ratio
limit on channel n Valid values are 0, or 5…31 percent of full scale. A
value of 0 disables this feature. Refer to the HART
Current Ratio table for more information.
AFSn Channel n Analog Fault
Mode Selection Refer to the Channel Analog Fault Mode Selection
table
Ln Channel n Enable Latching
of wire fault 0: Unlatched 1: Latched
DFn Channel n Digital Fault
Mode Selection 0: Reset (0 mA) 1: Hold Last State
DMn Channel n Enable Digital
Mode 0: Analog 1: Digital
Fn: Fault mode channel n 0: Local/Remote faults
disabled 1: Enabled
Configuration Map
Word Bit
15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0