Rockwell Automation 1794-OF8IH FLEX I/0 8 Isolated Output Analog Module - Manual (Page 7)

FLEX I/O Isolated Output HART Analog Module 7
Publication 1794-IN120C-EN-P - April 2009
Install the Module
Read this for information about how to install the module, which
mounts on a 1794-TB3 or 1794-TB3S terminal base.
To install the module on a 1794 terminal base, refer to the figure and
complete the following.
1. Rotate the keyswitch (1) on the terminal base (2) clockwise to
position 3 as required for this type of module.
2. Make sure the flexbus connector (3) is pushed all the way to
the left to connect with the neighboring terminal base or
adapter.
ATTENTION
During mounting of all devices, be sure that all debris (such as metal chips or
wire strands) is kept from falling into the module. Debris that falls into the
module could cause damage on power up.
IMPORTANT You cannot install the module unless the connector is fully extended.
44341
3
4
7
1
2
6
5