Rockwell Automation 2706-D11JS_D21JS Dataliner DL5 Slave Displays - Manual (Page 11)

Publication 2706-6.4
Chapter
2
Installation and Startup
Chapter Objectives This chapter describes how to mount and make electrical connections to the
DL5 Slave display. The following topics are described:
• Mounting Instructions
• Panel Cutout Dimensions
• Power Connections
• Powerup Sequence
Mounting the DL5 Slave The following pages provide panel cutout dimensions and overall
dimensions for the DL5 Slave displays.
You can also mount the DL5 Slaves in a custom panel or enclosure. When a
DL5 Slave is properly installed, the faceplate of the DL5 Slave provides a
NEMA Type 12/13 and 4 enclosure rating. To install the DL5 Slave:
1. Cut and drill the appropriate mounting holes in the enclosure or panel as
shown on the following pages.
2. Remove the four mounting nuts from the mounting studs on the display.
3. Position the DL5 Slave in the panel or enclosure mounting hole.
4. Install and alternately tighten the nuts to a torque of 9in • lbs (1.02N • m).