Rockwell Automation 2706-D11JS_D21JS Dataliner DL5 Slave Displays - Manual (Page 19)

Publication 2706-6.4
Installation and Startup 2-9
Startup Sequence When power is applied to the DL5 Slave a powerup sequence of displays
are shown. The first display on powerup is the sign-on banner identifying
the hardware and firmware:
Following the sign-on banner, all of the display pixels are turned on for 2
seconds followed by a series of informational messages indicating the
current DIP switch settings. Each display lasts for about four seconds.
After the status messages are displayed, the DL5 Slave clears the display
and enters the selected run mode. Note: if the Operate / configure switch is
in the Configure position (position 1, down), the DL5 Slave displays:
MODE = (Current Operating Mode)
DL5 SLAVE 2L
V1.00 04/02/99
DL SLAVE MODE
DL SLAVE MODE
PV SLAVE MODE
TERMINAL MODE
DIAGNOSTIC MODE
SERIAL ADDRESS: XXX
0 to 127
9600 BAUD N-8-1
9600
1200
300
Parity / Data Bits / Stop Bits
N - 8 - 1
Addresses 13 & 18 are not valid
Note: Only displayed for DL Slave mode
CURSOR ENABLED
AUTO LINE ENABLED
CURSOR ENABLED
CURSOR DISABLED
AUTO LINE ENABLED
AUTO LINE DISABLED
Note: Only displayed for PV Slave
or Terminal modes