Rockwell Automation AutoMax Enhanced Ladder Editor - Manual (Page 37)

3Ć3
When you print the Program (task) crossĆreference, it prints at the
end of the printout and is printed for the entire program, even if you
selected only a range of rungs to print. The program crossĆreference
contains the following items:
variable name table This table includes each variable used in
the task, its data type, the instruction and
rung where it is used, its I/O type, the
hardware address, its description, and the
line crossĆreference. If the database does
not exist, the text Unknown" is printed for
the descriptions and crossĆreference
information.
rung table This table includes information about each
variable used as an output in the program,
including the rung number where the
variable appears, its name, the instruction
symbol or mnemonic in which the variable
is used, I/O description, and the variable
description from the program variable
table.
messages The Editor prints any messages about the
crossĆreference summary, verify result
summaries, print processing, and
database processing after the rung table.
When printing the program from the Editor,
verify warnings are printed if you have not
selected Ignore Warnings in the General
Tab.
The items in the program are printed in the following order:
1. rungs
2. instruction crossĆreference (if selected)
3. initial value table
4. program crossĆreference, including the variable table, rung list,
legends, scan information, verify error statement, and summary (if
selected)