Rockwell Automation AutoMax Enhanced Ladder Editor - Manual (Page 38)

3Ć4
3.2 Setting Print Options
You can choose the type of information to print on your programs'
printout. Choose to print or not to print the following:
To print: Choose: Result:
a program's ladder
logic rungs
Rungs The rungs are printed.
any description
assigned to rung
Rung
Descriptions
The rung descriptions print
above the rung.
The line length is the same as
the page width. The description
is truncated if it is longer than
the page width.
only rung descriptions Rung
Descriptions Only
The rungs, variable descriptions,
and instruction crossĆreference
are not printed.
You can also choose to print the
program crossĆreferences when
you choose Rung Descriptions
Only.
any description
assigned to a variable
Variable
Descriptions
The variable descriptions are
taken from program symbol
table and are printed above
variable name, just as they are
displayed in the program.
information that helps
you track where
variable names are
written and where they
are read
Instruction
CrossĆReference
The instruction crossĆreference
is printed with each rung.
When only a range of rungs is
selected, the instruction
crossĆreference still includes
references for the entire
program.
variable name table
and a rung table
Program
CrossĆReference
The program (task)
crossĆreference prints at the end
of the program printout after the
rungs. Included is a variable
name table and a rung number
table.
When only a range of rungs is
selected, the program
crossĆreference is still printed
and provides references for the
entire program.
Choose any print options on the Print Options Tab, which you can
access from the Tools menu or from the Print dialog box. These
items are printed by default:
D rungs
D variable and rung descriptions
D program and instruction crossĆreferences