Rockwell Automation 61C345 4 Input 4-20mA Analog Rail Module - Manual (Page 38)

5Ć6
e) Place the metal enclosure side of the leftĆhand piece
on a clean surface. Note the position of the fuses from
the drawing below. As shown on the drawing, the top
fuse is for channel 0 and the bottom fuse is for
channel 3. The fuses are held in place by spring clips
and are marked F1, F2, F3 and F4. Remove the blown
fuse(s) carefully and discard. Replace the fuse(s) with
a new fuse.
Transformer
Printed Circuit Board Facing Up
12 point
Module
Faceplate
4 point
Connector
Mating Half
Connector
Mating Half
Channel 2
Channel 3
32mA Fuses
Channel 0
Channel 1
Figure 5.2 Ć Replacing the 32mA Fuse
f) Using the reserved screws, reĆattach the printed
circuit board assembly to the metal enclosure, making
certain that the lip on the metal enclosure is covered
by the printed circuit board assembly. If the module is
reĆassembled incorrectly, the screw holes will not line
up properly.
g) ReĆattach the two connectors to the faceplate of the
module. Turn on power to the module. Turn on power
to the external hardware.