Rockwell Automation 5370 CVIM Communications Manual - Manual (Page 127)

Chapter 5
Using the RS-232 Ports
5–57
err = get_message(portnum,reply, & replen);
break;
case 7: /* read results block 1 tool set 2 */
err =send_message(portnum,”\007\000\001\025\001”,5);
if (!err)
{
err = get_message(portnum,results, & reslen);
if (!err)
printf (”Results block #1:\n”);
/* Display the results block */
for (x=0; x<reslen; x+=2);
printf (”%04x”, results [x] *256 + results [x+1]);
printf (”\n”);
}
}
break;
case 8:
err =send_message(portnum,”\026\000\062\004\000\000\000\000”
”\001\000\000\000\000\000\000\000\000\000\000\000”,20);
for (x=0; x<5000 x++); /* give CVIM time to prepare */
if (err)
{
err = send_message(portnum, ”\27\0\1”, 3);
if (err)
{
err = get_message(portnum,results, & reslen);
for (x=0; x<5000 x++); /* give CVIM time to prepare */
if (err)
{
printf (”Gage #1 Stats \n”);
for (x=0; x<reslen; x+=2);
printf (”%04x”, results [x] *256 + results [x+1]);
printf (”\n”);
}
}
}
break;
case 9: /* read configuration */
/* read all config. blocks */
err =send_message(portnum,”\6\7\377\377\377\377\377\377\377”
”\377\377\377\377\377\377\377\377\377\377”,19);
if (err)
{
/* read config blocks 1-135 */
for (x—0 (x<135) && !err; x++)
err = get_message(portnum, config [x] & config [x]);