Rockwell Automation 6185-F RAC6185 Industrial Flat Panel Monitors User Manual - Manual (Page 19)

Publication 6185-UM006A-EN-P - July 2002
Installation 2-9
Installing Your Monitor Into a Rack
1. Locate holes in the rack mounting rails corresponding to the holes in
the monitor front panel. Install clip nuts behind the holes in the rails if
threaded rails are not provided.
2. Install the monitor into the cabinet from the front.
3. Secure the monitor chassis to the cabinet by installing panel-mounting
screws through the holes in the monitor’s front panel and into the rails
behind.
IMPORTANT
The mounting rails that run vertically along the inside
edges of the front opening of an EIA rack cabinet can be
of two types:
• “Wide” rails have holes spaced 0.5 in (12.7 mm) and
1.25 in (31.8 mm) on centers, in a repeating pattern.
Wide rails are prevalent in Europe.
• “Universal” rails have holes spaced 0.5 in (12.7 mm),
0.625 in (31.8 mm), and 0.625 in (31.8 mm) on centers,
in a repeating pattern. Thus, the universal rails have a
hole pattern that contains the wide pattern but provides
an additional hole at the midpoint of the pattern.
Universal rails are most prevalent in the US.