Rockwell Automation 6185-F RAC6185 Industrial Flat Panel Monitors User Manual - Manual (Page 27)

Publication 6185-UM006A-EN-P - July 2002
Configuring the Video Setup 3-5
Adjusting Your Monitor To adjust your 6185-F monitor, you will use the buttons on the small keypad
located at the rear of the unit
Figure 3.1 User Control Keypad
Performing Automatic Setup
The RAC6185 Industrial Flat Panel Monitor (6185-F) can sample the input
video signal and set themselves up with a press of the Auto setup button. For
most users, the Auto Setup feature quickly and accurately adjusts the monitor.
The Auto Setup function works with most screens using reasonable video
content, but Rockwell Automation ships a ScreenSet monitor setup utility on
CD-ROM to display the best possible image for setup.
1. Insert the ScreenSet Utility CD-ROM provided with the monitor into
your computer’s CD-ROM drive.
2. Start the ScreenSet utility using the instructions on the CD-ROM.
Control Description
On/Off Switch
• Turns monitor on and off
Menu
• Opens the OSD and sub-menus
• Selects the highlighted function
• Locks the user control keypad when pressed and
held for 8 seconds
Adjust Buttons +/-
• Moves between OSD menus and submenus
• Decreases or increases values in OSD menus and
submenus
• Adjusts the brightness level of the monitor if
pressed while the OSD is off
Exit • Exits the active On-Screen Display (OSD) menu
• Exits the OSD
Auto
• Starts the Automatic Video Adjustment function
IMPORTANT
The ScreenSet monitor setup utility is designed for 32-bit
Windows operating systems only (Windows 95/98/2000 or
Windows NT 4.0 or greater).
Auto
Exit
Menu