Rockwell Automation 6185-F RAC6185 Industrial Flat Panel Monitors User Manual - Manual (Page 41)

1 Publication 6185-UM006A-EN-P - July 2002
Appendix
A
Installing Rack Brackets on the RAC6185
Industrial Flat Panel Monitor (6185-F)
You can install the RAC6185 Industrial Flat Panel Monitor (6185-F) monitor
into a rack using optional rack adapters. The rack adapters are designed for
installation in a rack cabinet that conforms to EIA standards for equipment
with 19” (483mm) wide panels. The rack adapter option is Accessory option
R.
Installing Rack Adapter
Brackets 1. Carefully remove the monitor from its packaging.
2. Locate four mounting studs on each side of the monitor’s back
enclosure.
3. Install handles onto rack adapter brackets, if required.
4. Install the rack adapter brackets onto the four mounting studs on the
monitor’s back enclosure.
Figure A.1 Generic rack adapter brackets installation
5. Secure the rack adapter brackets with the provide nuts for all 8
mounting studs (4 studs for each rack adapter bracket).