Rockwell Automation 1797-RPFM ControlNet Ex Modular Repeater Adapter Fiber Repeater Module - Manual (Page 6)

6 ControlNet Ex Modular Repeater Adapter & Fiber Repeater Module
Publication 1797-5.15 - June 2010
3. Press the adapter down onto the DIN rail until flush.
The locking tab should snap into position and lock the module to the
DIN rail.
4. If the adapter does not snap into position, use a screwdriver or similar
device to move the locking tab down while pressing the module flush
onto the DIN rail.
Release the locking tab to lock the module in place. If necessary, push
up on the locking tab to lock.
5. Remove the adapter backplane connector cover.
6. Follow steps 1 to 4 to attach fiber modules to the DIN rail.
7. Once attached to the DIN rail, slide fiber modules to the left to mate
with the adapter.
ATTENTION
Make certain that the adapter and fiber modules are secured
together with DIN rail anchors. Failure to do so may result in
the loss of communications, cause damage to the modules, or
both.
41168