Rockwell Automation 2711-M3A18L1_M3A19L1 PanelView 300 Micro Terminals Installation Instructions - Manual (Page 12)

12 PanelView 300 Micro Terminal
41061-156-01(A)
3. Gently push the blade of the screw driver away from the terminal block to
release locking mechanism.
4. Remove DC power terminal block.
To re-install the DC power terminal block
Note: Install the terminal block with or without the power wires connected.
1. Disconnect all electrical power from the panel prior to installation. See
Explosion Hazard Warning on previous page.
2. Position the terminal block at a 45
°
angle to the base surface and place lower
edge of the wire connection side into the base.
3. Gently push the top of the terminal block back to a vertical position to snap in
the locking tab.
Insert tip of screw driver here.
Press terminal block
base in first with
block leaning outward
Push top back to
vertical position
to lock-in.