Rockwell Automation 2711-M3A18L1_M3A19L1 PanelView 300 Micro Terminals Installation Instructions - Manual (Page 19)

PanelView 300 Micro Terminal 19
41061-156-01(A)
Comm and Fault Indicators
The PanelView 300 Micro has a Comm (communication) and Fault (error) status
indicator. These indicators are visible from Configuration Mode when selecting
the Communication screen. Use the Comm and Fault indicators to isolate
operating problems.
Indicator State Indicates
Comm ON (steady state solid fill) Normal Operating (no communications fault)
OFF (no fill) Fault detected. Verify:
• controller is in run mode.
• communication settings for terminal and
controller.
• terminal and controller node addresses.
• terminal to controller connections.
Blinking (flashing) No communications established. For DF1 terminals,
the Comm indicator flashes until an application is
loaded.
Fault OFF (no fill pattern) Normal operating state
ON (steady state solid fill) Fault detected. Reset or cycle power to the terminal.
If the fault remains the terminal requires servicing.
Blinking (flashing) Hardware is functioning but no application is loaded
in the terminal or the current application is
corrupted. Reload the application file into the
terminal.
DF1 - Full Duplex
Comm Fault
PanelView Online
F3 MORE F4 EXIT
C
F2 RESET VIDEO F
F1 RUN MODE
Language
Communication
Preset Operations
CONFIGURATION MODE