Rockwell Automation 5370-OCR2 PAK - Manual (Page 19)

Chapter 3
OCR2-PAK Installation
3–2
5. While the package is being installed, you will see the following message:
Loading package MC:OCR2–B01
into
V1:OCR2–B01
6. When the Memory Active LED goes off and the screen displays the
CVIM2 power up message, the downloading is complete. Verify that the
power–up banner shows that OCR2–PAK has been installed.
On subsequent powerups, you are provided with the option to abort the
running of all installed packages:
6 seconds to package run
Abort Package Run
If you abort the running of installed packages, the module will function as if
the packages were not installed.
Note: You only need to install the OCR2-PAK once. After installation,
OCR2-PAK remains installed for all subsequent powerups.
After OCR2-PAK is installed, OCR is listed as an option on the Tool Types
panel as shown below.
Select to Create
an OCR Tool
Accessing OCR2-PAK