Rockwell Automation 5370-OCR2 PAK - Manual (Page 20)

A–B
4
Chapter
4–1
OCR Tool Configuration
This chapter describes how to:
•
Create an OCR Tool
•
Configure an OCR Tool
The steps for creating an OCR Tool are listed below. You must perform the
steps in the same sequence. If you are using Optical Character Verification
(OCV), refer also to Chapter 6.
1) Add an OCR Tool in the toolset.
2) Edit the OCR Tool configuration.
3) Enter a Font Name.
4) Position Tool Window.
5) Set Threshold/Filter.
6) Set Character Size.
7) Enter and Teach characters.
8) Test taught characters.
9) Select string modes.
10) Enter match strings for OCV mode.
11) Select OCV options if required.
Refer to this Chapter
Refer to Chapter 5
Refer to Chapter 6
Chapter Objectives
Procedure