Rockwell Automation RSBizWare BatchCampaign Users Guide - Manual (Page 17)

3 • Installing RSBizWare BatchCampaign
23
•
•
•
• •
installation at any time by clicking the Cancel button. Before you begin the installation,
complete all the pre-installation procedures.
1. Insert the installation CD into the CD-ROM drive. The CD has the Autorun feature
enabled so the installation process starts automatically. The RSBizWare Welcome
dialog box opens.
2. Click Install RSBizWare BatchCampaign. The RSBizWare BatchCampaign
Install Disk dialog box opens.
The following steps assume that FactoryTalk Activation was installed before the Batch Server. If
you find that you do need to install FactoryTalk Activation, please refer to the Activate Rockwell
Software Products brochure, located in your product package, for instructions.
To start the installation process manually, click the Start button, and then select Run. In the Run
dialog box, type d:\setup (where d is the drive letter for the CD-ROM drive), and then click OK.
If the installation program detects an existing FactoryTalk Batch installation, it may give you the
option of modifying or repairing the current installation. Do not select Repair or Modify - these are
not supported options. You must remove the existing version of the software before installing the
upgrade.
BatchCampaign.book Page 23 Wednesday, September 19, 2007 4:58 PM