Rockwell Automation 57C419 5V-24V DC Input Module - Manual (Page 16)

3Ć4
3.3 Module Replacement
Use the following procedure to replace a module:
Step 1.
Turn off power to the rack and all connections.
Step 2. Use a screwdriver to loosen the screws holding the
connector to the module. Remove the connector.
Step 3. Loosen the screws that hold the module in the rack.
Remove the module from the slot in the rack.
Step 4. Place the module in the antiĆstatic bag it came in, being
careful not to touch the connectors on the back of the
module. Place the module in the cardboard shipping
container.
Step 5. Take the new module out ofthe antiĆstatic bag, being
careful not to touch the connectors on the back of the
module.
Step 6. Insert the module into the desired slot in the rack. Use a
screwdriver to secure the module into the slot.
Step 7. Attach the field terminal connector (M/N 57C375) to the
mating halfon the module. Make certain that the
connector keys are in the proper position for this module.
Use a screwdriver to secure the connector to the module.
Step 8. Turn on power to the rack.