Rockwell Automation 6185-A 10 Inch Monitor User Manual - Manual (Page 10)

10 Industrial 10.4" Flat Panel Monitor
Publication 6185-5.0
Panel Mounting Procedure
1. Cut and drill the panel (refer to following figure). Units are in mm
[inches].
Note: Use #10-32 or M5 self-locking nuts for mounting.
Figure 5
Panel Mounting Cutout
2. If access to the side of the monitor is not available following
installation, attach the power and video cables to the side of the
monitor at this time.
3. Install the monitor in the prepared cutout. Refer to the figure on this
page.
4. Install lock nuts and washers, supplied with the monitor, behind the
holes running along the sides and top/bottom of the cutout in the
panel.