Rockwell Automation 6185-A 10 Inch Monitor User Manual User Manual
Page 21
Industrial 10.4" Flat Panel Monitor
21
Publication 6185-5.0
Figure 9
Controls on Back Panel (Labels)
Display Active Indicator (A)
Indicates monitor “OK” (steady) or video adjustment mode (blinking).
Green LED.
Fault Indicator (F)
Indicates system “Fault” (steady) or video adjustment mode (blinking).
Red LED.
Clock Adjust (Clk)
Adjusts the clock phase of the monitor to best match to the video clock
rate.
Reset (Rst)
Resets and reinitializes the monitor controller. Also turns off the
backlight until the monitor signals stabilize. This is the same as power up
reset.
Vertical Position (V)
Activates the vertical video framing mode.
Horizontal Size/Position (H)
Activates the horizontal video framing mode or the video frame width.
Function 1 (+)
Adjustment in the video framing mode or video frame width.
Function 2 (-)
Adjustment in the video framing mode or video frame width.
Contrast ( )
Adjusts the difference between the monitor's light and dark elements.
With a suitable image displayed on the screen, adjust the contrast control
to achieve the best balance between image brightness and fine detail
rendition.
Brightness (
)
Adjusts the overall intensity of the monitor. After allowing the backlight
to warm up for at least one minute, adjust for the least amount of
brightness needed to achieve desired clarity.