Rockwell Automation 6185-A 10 Inch Monitor User Manual - Manual (Page 22)

22 Industrial 10.4" Flat Panel Monitor
Publication 6185-5.0
Cleaning
Occasionally clean the display panel and cabinet with a soft cloth
dampened (not soaked) with a mild (non-abrasive) glass cleaner. Keep
turning a fresh side of the cloth toward the screen surface to avoid
scratching it with accumulated grit.
Note: The solvent should be applied only to the cloth, and not
directly on the monitor screen.
Do not use paper products as they may scratch the surface.
To minimize the risk of abrasion, allow the screen to
stand dry.
Special care should be taken when cleaning a touchscreen or
polycarbonate shield that is installed over the screen. Abrasive and
certain chemical cleaners can easily damage the surface. Never use
alcoholic or ammoniac cleaners.
Replacing a Line Cord
To avoid shock and fire hazards, the monitor’s power cord should be
replaced if the insulation becomes broken or if it develops a loose
internal connection.
Other Maintenance
Qualified service personnel should perform all maintenance, except for
the power cord replacement described above and the backlight
replacement explained in Appendix C (Page 28).
Routine Maintenance