Rockwell Automation 6185-A 10 Inch Monitor User Manual - Manual (Page 5)

Industrial 10.4" Flat Panel Monitor 5
Publication 6185-5.0
This section describes how to install the monitor.
Tools Needed
In addition to the tools required to make the cutout, you will need the
following tools:
•
3/8” Deep Well Socket
•
1/4” Drive Extension - 6” or longer
•
1/4” Drive Ratchet or 1/4” Drive Torque Ratchet
Before Installation
When installing the unit, it is important to consider environmental
factors at the site that could affect performance as well as possible
effects from equipment operation on personnel and nearby equipment.
Following the guidelines will help ensure that the monitor will provide
safe and reliable service.
•
Ensure that sufficient power is available from a single phase AC
outlet at the site.
•
Ensure that sufficient space is available around air inlets and outlets
to provide the circulation necessary for cooling. Never allow air
passages to become obstructed.
•
Ensure that the ambient air temperature will not exceed the
specified maximum temperature. A user supplied fan, heat exchanger
or air conditioner may be required to meet this condition in some
installations.
•
Leave the monitor’s enclosure or cover in place at all times during
operation. The cover affords protection against high voltages inside
the monitor and inhibits radio-frequency emissions that might
interfere with other equipment.
•
The Federal Communications Commission has prepared a pamphlet
that addresses the problem of radio frequency interference to radio
and television reception, which should be consulted in case of
problems with such interference. This publication, “How to Identify
and Resolve Radio/TV Interference Problems” (Stock #004-000-
00345-4) may be obtained from the US. Government Printing Office,
Washington, DC 20402.
Installing the 6185-A Flat
Panel Monitor