Rockwell Automation 6185-A 10 Inch Monitor User Manual - Manual (Page 14)

14 Industrial 10.4" Flat Panel Monitor
Publication 6185-5.0
Connecting AC Power
The 6185-A Flat Panel Monitor requires a single phase power supply
providing 85 to 264V AC at 47 to 70 Hz. Power must be available at a
grounded three-pin outlet located nearby. Whenever possible, connect
the monitor to the same AC source that supplies the computer.
To connect AC power to the monitor:
1. Turn off the main switch or breaker.
2. Use the ground terminal of the monitor (below the power, video and
T/S connectors) to establish a chassis-to-earth ground connection.
Secure one end of a ground strap to the ground terminal. Connect
the other end of the ground strap to a good earth ground.
The ground terminal is an M5 screw.
ATTENTION: Chassis ground must be connected for
safe operation of the monitor. The AC receptacle on the
monitor is a 3-wire type with chassis ground pin, and the
mating AC cord supplied is a 3-wire type, designed for
connection to a grounded 3-pin AC outlet. However, a
properly ground AC outlet is not always available, and
grounding using a 3-wire cord can easily be defeated. If
you fail to ground the monitor properly, the setup may
result in personal injury from electrical shock or damage
to the equipment.
3. Connect the socket end of the AC power cord to the mating
connector on the rear panel of the monitor. Position the power cord
retaining clip attached to the rear panel connector over the cord’s
socket to secure it in place.
4. Connect the plug end of the AC power cord to the main outlet.
5. Restore AC power to the outlet.