Rockwell Automation System Release 3.0 PlantPAx System Application Templates Quick Start - Manual (Page 15)

Rockwell Automation Publication PROCES-QS001A-EN-P - October 2013 15
Configure the Controller Application Chapter 1
4. From the Type pull-down menu, choose a controller
5. From the Revision pull-down menu, choose your firmware revision.
6. Click OK.
A dialog box appears with a warning if the controller type or revision has changed.
7. Click Yes.
8. If the target controller is redundant, click the Redundancy tab and check the Redundancy Enabled checkbox.
Otherwise, skip this step.
9. Click OK to save your controller settings.
IMPORTANT Refer to Table 2 on page 12 to make sure the controller has enough memory for the selected template.
IMPORTANT The revision number for the firmware must match the version level of the software being used. For PlantPAx system
release 3.0, select revision 20
.
If you are using redundancy (see step 8 ), we recommend you verify the software that you are using supports redundancy.