Configure network adapters – Rockwell Automation System Release 3.0 PlantPAx System Application Templates Quick Start User Manual
Page 18
18
Rockwell Automation Publication PROCES-QS001A-EN-P - October 2013
Chapter 1 Configure the Controller Application
If applicable for your selected module, from the Major Revision pull-down menu, choose a firmware revision.
4. Click OK.
5. On the New Module dialog box, type a module name, description, and slot number (and IP address if adding a
communication module).
6. Click OK.
7. Repeat
to add each module in the local chassis of the target controller.
Configure Network Adapters
In this section, you learn how to select and configure network adapters to communicate with PASS servers and remote
I/O chassis.
1. In the Controller Organizer, double-click the module to be configured.
2. On the Module Properties dialog box, modify the module name, if necessary.
For example, Supervisory_Network or Remote_IO_Local.
TIP
Make sure the slot number for the module in the chassis is correct.