Hapter, Mounting the drive, 1 planning the installation – Rockwell Automation TD200 AC Drive V1.0, 0.3-20V RMS, 3-Ph, 63A User Manual
Page 17: 2 mounting the drive
Mounting the Drive
3-1
C
HAPTER
3
Mounting the Drive
3.1
Planning the Installation
The drive should be installed in a location where high airflow and low ambient
temperatures are present. The jumpers must be configured before installation,
because their access is from the bottom of the unit.
3.2
Mounting the Drive
Use the following steps to mount the drive.
Step 1. Prepare the mounting surface based on the dimensions shown in figure 3.1.
Step 2. Position the drive in the enclosure. Choose the mounting surface (horizontal
or vertical) to provide maximum airflow through the fin area.
Step 3. Attach the drive to the mounting surface using four fasteners.
Figure 3.1 – Drive Mounting Dimensions
.33
4 Places
12.25
12.95
6.50
3.00
4.12
3.75
Dimensions in inches
Front View
Side View
0.25
0.25