Rockwell Automation TD200 AC Drive V1.0, 0.3-20V RMS, 3-Ph, 63A - Manual (Page 25)

Operating the Drive 6-1
C
HAPTER
6
Operating the Drive
The following table describes how to start and stop the drive, and how to change the
motor speed. This table assumes that the drive is wired as shown in figure 4.1.
Table 6.1 – Operating the Drive
Function Process
Start the drive Apply 28 VDC to the ON/OFF terminal.
Stop the drive Remove 28 VDC to the ON/OFF terminal.
Adjust motor speed Motor speed can be controlled by:
• jumper settings (see section 2.3).
• speed potentiometer (see section 2.6).
• external voltage control (see section 2.6).
• application of 28 VDC to HI/LO terminal. This will
reduce motor speed by 75%.