Rockwell Automation TD200 AC Drive V1.0, 0.3-20V RMS, 3-Ph, 63A - Manual (Page 21)

Wiring the Drive 4-3
4.3 Wiring Input Power to the Drive
Table 4.3 describes the input power connections to the drive as shown in figure 4.1. All
input power connections should be wired as follows:
• Minimum 6 AWG wire terminated with ring lugs sized for a 3/8” stud (drive end).
• torque all connections between 90 to 100 in-lb.
!
ATTENTION: The input power of this drive is not internally fused. The
user is responsible for external fusing. Failure to observe this precaution
could result in damage to, or destruction of, the equipment.
ATTENTION: Applying reverse polarity at the drive input terminals will
allow unlimited input current to flow. A user-supplied fast-acting fuse or
circuit breaker should be installed in the drive input circuit to prevent
damage to the drive. Failure to observe this precaution could result in
damage to, or destruction of, the equipment.
Table 4.3 – Output Power Connections
Terminal Label Function
+28 V Connect to power source +28 VDC terminal
GND Connect to power source ground terminal