Rockwell Automation TD200 AC Drive V1.0, 0.3-20V RMS, 3-Ph, 63A - Manual (Page 23)

Checking the Installation 5-1
C
HAPTER
5
Checking the Installation
To ensure safe operation, check the installation with the power off before operating the
unit. When power is first applied, the direction of rotation, operator speed reference,
and operation under load should be tested.
5.1 Checking the Installation with the Power Off
Perform the following installation checks of the unit with the power off:
Step 1. Disconnect DC input power to the unit.
Step 2. Check that the wiring to the power terminals and to the external control
inputs and outputs are correct (refer to figure 4.1 and sections 4.1 through
4.3).
Step 3. Check that incoming DC power is correctly rated.
Step 4. Where applicable, check that a properly sized ground wire is installed and
that a suitable earth ground is used. Verify that all ground leads are run
unbroken.
5.2 Checking the Direction of Motor Rotation
Important: If any problems occur while the drive is running, refer to chapter 7,
Diagnostics and Troubleshooting.
After verifying that the drive installation is correct, check the direction of rotation of the
motor using the following procedure:
Step 1. Disconnect DC input power to the unit.
Step 2. Uncouple the driven equipment from the motor, if possible.
Step 3. Connect input power to the unit.
Step 4. Start the drive.
!
ATTENTION: Only qualified electrical personnel, familiar with the
construction and operation of this equipment and the hazards involved,
should install, adjust, operate, and/or service this equipment. Read and
understand this manual in its entirety before proceeding. Failure to
observe this precaution could result in severe bodily injury or loss of life.
!
ATTENTION: The following procedures require rotating parts and/or
electrical circuits to be exposed. Stay clear if the motor must be running.
Disconnect, lockout, and tag the power source if contact must be made.
Failure to observe this precaution could result in severe bodily injury or
loss of life.