Rockwell Automation 1440-PK02-05M2 XM-720 Machine Monitor - Manual (Page 27)

Publication GMSI10-UM001C-EN-E - June 2011
Installing the XM-720 Machine Monitor 27
Figure 2.13 Powered Sensor Wiring
IMPORTANT
A jumper from terminal 5 to 6 on the XM-120/121/122
terminal block is required for channel 1 buffered output. A
jumper from terminal 22 to 6 on XM-120/121/122
terminal block is required for channel 2 buffered output.
Refer to Setting the Buffer Range for the Transducer on
page 20.
+24V DC
Common
Signal
TYPICAL WIRING FOR ENTE K MODEL 580 VIBRATION PICKUP
TO XM-720 BACK PANEL
Cable shield not
connected at this end
17
18
19
20
21
22
23
Channel 1 Input Signal
Signal Common
Shield
+24V DC
+24V DC
Signal
Common
23
Channel 2 Input Signal
Signal Common
Shield
+24V DC