Rockwell Automation 1440-PK02-05M2 XM-720 Machine Monitor - Manual (Page 6)

Publication GMSI10-UM001C-EN-E - June 2011
6 Introduction
Figure 1.1 XM-720 Front and Side View
Each monitor offers:
• two vibration transducer connections (eddy current probes,
accelerometers, velocity sensors, AC voltage output or DC voltage
output measurement devices)
• one tachometer input signal connection
• remote relay reset connection
• three relays available for module or transducer fault, warning and trip
• isolated 4-20mA per channel into a maximum load of 250 ohm
• three buffered output signals on the front panel BNC connectors
• two front panel digital meters
• four front panel LED indicators (module, transducer, warning, and trip
status)
System Description The concept of machine monitoring is quite simple. During normal operation,
the machine’s "vital signs" remain within relatively narrow ranges. If a
mechanical problem develops, it will be reflected as a change in one or more of
these vital signs. This change will be detected by the XM-720 and cause an
alarm.
The monitoring system consists of a number of transducers connected to the
XM-720. The transducers installed on the machine convert the "vital signs" to
electrical signals that are transmitted to the XM-720 monitor.
The XM-720 accepts the signals from the transducers, processes and measures
the signals, and closes electrical relay contacts if one of the signals increases
too much. The relays can be connected to annunciators or to automatic
machine controls.
1 2 3 4 5 6 7 8 9 10 0
16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33
34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51
11 12 13 14 15 1 2 3 4 5 6 7 8 9 10 0
16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33
34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51
11 12 13 14 15
Warning
Trip
Module
Fault
Xdcr
Fault
Reset
Tacho CH 2 CH 1
% 0
25
50
75
%
100
0
25
50
75
100
XM-120/121/122 module XM-441 module