Rockwell Automation MD60 Serial Converter Module - M/N MDCOMM 232 - Manual (Page 2)

Copyright © 2003 Rockwell Automation. All rights reserved.
The information in this manual is subject to change without notice.
Throughout this manual, the following notes are used to alert you to safety
considerations:
Important: Identifies information that is critical for successful application
and understanding of the product.
!
ATTENTION: Identifies information about practices or
circumstances that can lead to personal injury or death,
property damage, or economic loss.
The thick black bar shown on the outside margin of this page will be used
throughout this instruction manual to signify new or revised text or figures.
Reliance, MD60, MD65. and VS Utilities are trademarks of Rockwell
Automation.
Trademarks not belonging to Rockwell Automation are property of their
respective companies.
!
ATTENTION: Only qualified electrical personnel familiar with
the construction and operation of this equipment and the
hazards involved should install, adjust, operate, and/or service
this equipment. Read and understand this manual in its
entirety before proceeding. Failure to observe these
precautions could result in bodily injury and/or damage to
equipment.
ATTENTION: If the Serial Converter is transmitting control I/O
to the product (indicated by a steady green diamond LED on
the Serial Converter), the product may fault when you remove
or reset the Serial Converter. Determine how your product will
respond before removing or resetting a connected Serial
Converter. Failure to observe this precaution could result in
bodily injury and/or damage to equipment.
ATTENTION: The setting of Comm Flt Action (04) determines
the action of the Serial Converter and connected product if
DF1 serial communications are disrupted. By default, this
parameter faults the product. You can set this parameter so
that the product continues to run. Ensure that the setting of
this parameter does not create a hazard. Failure to observe
this precaution could result in bodily injury and/or damage to
equipment.