Rockwell Automation MD60 Serial Converter Module - M/N MDCOMM 232 - Manual (Page 9)

Introduction 1-1
C
HAPTER
1
Introduction
The Serial Converter module (MDCOMM-232) provides an
electronic communications interface between a computer and an
MD60 or MD65 AC drive. It uses the full-duplex, RS-232 DF1
protocol.
The Serial Converter receives power from the connection to the
host product. An outside power source is not required.
This manual is intended for qualified electrical personnel.
For definitions of terms in this manual, refer to the Glossary.
1.1 Serial Converter Module Features
Features of the Serial Converter module include the following:
• Three status indicators (LEDs) report the operating status of the
module.
• DF1 serial baud rates of 9600 bps, 19.2 Kbps, and 38.4 Kbps are
supported. 9600 bps is the factory default.
• A number of configuration tools can be used to configure the
module, such as VS Utilities (V3.01 or higher) or terminal
emulation software.
1.2 Related Publications
Refer to the following related publications as necessary for more
information:
• 1770-6.5.16 - DF1 Protocol and Command Set Reference Manual
• D2-3488 - VS Utilities Getting Results Manual
These publications are available from:
http://www.theautomationbookstore.com