Rockwell Automation SA3100 AC Power Modules - Manual (Page 11)

Introduction 1-3
1.1 Standard Features
Distributed Power System SA3100 Power Modules have the following features:
• Input power supplied from a three-phase AC line or a common DC bus
• PWM inverter to convert DC power to variable frequency AC power for 3-phase
induction motors
• IGBT power semiconductors
• Carrier switching frequencies from 1 to 12 kHz, 1 to 6 kHz, or 1 to 4 kHz, depending
upon model (See Appendix A).
• Short circuit protected outputs
• Electronic motor overload protection
• Fiber-optic communication with the Distributed Power System host, the Universal
Drive Controller (UDC) module
• MOV surge protection
• On-line diagnostics
• UL Listed/CUL Certified
1.2 Related Publications
This manual describes the SA3100 Power Module hardware. Installation guidelines
are also provided. Additional information about using the SA3100 drive is found in the
wiring diagrams, prints, and other documentation shipped with each drive system.
Always consult the prints shipped with your drive system for specific information about
installing, operating, and maintaining your drive.
The other instruction manuals in binder S-3053 describe the SA3100 PMI Regulator,
software, and communications. Table 1.1 lists the document part numbers.
Table 1.2 – SA3100 Documentation (Binder S-3053)
Document Document Part Number
SA3100 Information Guide S-3054
Drive System Overview S-3005
Universal Drive Controller Module S-3007
Fiber Optic Cabling S-3009
SA3100 Drive Configuration & Programming S-3056
SA3100 PMI Regulator S-3057
SA3100 Power Modules S-3058
SA3100 Diagnostics, Troubleshooting, & Start-Up
Guidelines S-3059