Rockwell Automation SA3100 AC Power Modules - Manual (Page 117)

Index Index-1
I
NDEX
A
AC input, 2-1
AutoMax, 1-1
C
Capacitor bank assembly, 2-1
Catalog numbering scheme, 1-1
Common bus inverter configurations, C-1 to C-22
Conduit, 3-21
Controlling emissions, 3-24 to 3-25
D
DC input (common bus) supply, 3-9
DC-to-DC converters, 2-2
Description, 2-1 to 2-3
electrical, 2-3
mechanical, 2-1 to 2-2
Diagnostics and troubleshooting, 4-1 to 4-7
PMI regulator assembly components, 4-7
power module faults, 4-2 to 4-5
power module warnings, 4-5 to 4-6
recommended test equipment, 4-1 to 4-2
system diagnostics, 4-2
Documentation, 1-3
Drive inspection and start-up guidelines
checking the DC bus supply, 3-27
E
Emergency stop, 3-20
Externally generated interference, 3-23
F
Faults, 4-2 to 4-5
AC power technology (bit 11), 4-4
charge bus time-out (bit 6), 4-3 to 4-4
communication lost (bit 15), 4-5
DC bus overcurrent (bit 1), 4-3
DC bus overvoltage (bit 0), 4-3
ground current (bit 2), 4-3
instantaneous overcurrent (bit 3), 4-3
isolated 12V supply (bit 4), 4-3
overspeed (bit 9), 4-4
overtemperature (bit 7), 4-4
PMI regulator bus (bit 13), 4-4
resolver (bit 9), 4-4
resolver broken wire (bit 8), 4-4
UDC run (bit 14), 4-5
Fiber-optics communications ports, 2-2
Fuse selection, 3-9 to 3-10
common bus input, C-1 to C-21
fuse ratings, 3-10
G
Gate driver board, 2-2
Gate driver board connections, ?? to E-3
B-frame drives, E-1
C-frame drives, E-2
D-frame drives, E-3
Ground fault detection circuit, 2-1
Grounding
discrete control wiring, 3-23
high frequency ground currents, 3-23
motor cable, 3-22
power module safety ground (PE), 3-22
protecting sensitive circuits, 3-23
resolver/encoder wiring, 3-23
RFI filter, 3-25
signal wiring shields (TE), 3-23
Grounding, 3-22
I
Installation guidelines, 3-1 to 3-27
AC supply source requirements, 3-8
checking with power off, 3-26
checking with power on, 3-26
commissioning, 3-25 to 3-27
connecting the motor, 3-20 to 3-21
controlling emissions, 3-24 to 3-25
DC input (common bus) supply, 3-9
emergency stop, 3-20
grounding the drive and motor, 3-22 to 3-23
input line fuse selection, 3-9 to 3-10
isolating unbalanced distribution system, 3-8
line input disconnect, 3-9