Rockwell Automation SA500 Diagnostics, Troubleshooting Guide - Manual (Page 9)

Introduction 1-1
C
HAPTER
1
Introduction
This instruction manual is divided into two sections: 1) a description of SA500 drive
diagnostics and troubleshooting, 2) start-up guidelines. This manual is intended for
users of SA500 drives who have training and experience in AC drive control and who
are familiar with all other SA500 drive documentation.
The diagnostics and troubleshooting chapters (chapters 2-3) describe the error
checking built into the PMI Regulator operating system and how to use warning and
fault registers, LEDs, and the error log to diagnose drive problems.
Chapter 4 provides guidelines on starting up Distributed Power SA500 AC drives.
Although initial start-up services are usually provided by Rockwell personnel, it is
recommended that the user become familiar with the general guidelines in this chapter
in order to be better prepared to work with the Rockwell service engineer.
This manual does not describe specific applications of the standard SA500 hardware
and software. Always refer to the wiring diagrams supplied with your system for
information specific to your installation.
1.1 Related Publications
You user must become familiar with the other instruction manuals that describe the
SA500 drive system. The documentation that describes the SA500 drive is listed in
table 1.1.
Additional information about using the SA500 drive is found in the prints and other
documentation shipped with each drive system. Always consult the prints and other
documents shipped with your drive system for specific information about installing,
operating, and maintaining your drive.
Table 1.1 – SA500 Documentation (Binder S-3002)
Document Document Part Number
DPS Overview S-3005
Universal Drive Controller Module S-3007
Fiber Optic Cabling S-3009
SA500 DC Bus Supply S-3017
SA500 AC Power Modules S-3018
SA500 Diagnostics, Troubleshooting, & Start-Up
Guidelines S-3022
SA500 Information Guide S-3024
SA500 Drive Configuration & Programming S-3044