Rockwell Automation 1440-TTC06-00RE XM-362 Temperature Module - Manual (Page 23)

Publication GMSI10-UM008D-EN-P - August 2010
15
1. Position the terminal base on the 35 x 7.5 mm DIN rail (A).
2. Slide the terminal base unit over leaving room for the side
connector (B).
3. Rotate the terminal base onto the DIN rail with the top of the rail
hooked under the lip on the rear of the terminal base.
4. Press down on the terminal base unit to lock the terminal base on the
DIN rail. If the terminal base does not lock into place, use a screwdriver
or similar device to open the locking tab, press down on the terminal
base until flush with the DIN rail and release the locking tab to lock the
base in place.
Position terminal base at a slight angle and hook over the top of the DIN rail.