Rockwell Automation 1769-L16ER-BB1B_L18ER-BB1B_L18ERM-BB1B CompactLogix 5370 L1 Controllers System Quick Start - Manual (Page 10)

10 Rockwell Automation Publication IASIMP-QS024B-EN-P - December 2012
Preface
• Configuring an EtherNet/IP network
• Creating a Logix Designer project
About the CompactLogix 5370 L1 Controllers
These CompactLogix 5370 L1 controllers are available:
• 1769-L16ER-BB1B
• 1769-L18ER-BB1B
• 1769-L18ERM-BB1B
IMPORTANT You are not required to install nor configure an EtherNet/IP network to complete the tasks described in this quick
start. However, before you can complete the tasks described in some of the publications listed on
page 12 , you
must first install an EtherNet/IP network.
For example, Chapter 4, on Create a Logix Designer Project on page 51 describes how to use ladder logic to test a
1734-OB4E output module. The test is completed by using the output module in a local expansion slot in the
CompactLogix 5370 L1 control system and does not require use of a 1783-EMS08T Stratix 6000 managed switch
because it can be done via a USB connection to the controller.
If you use 1734 POINT I/O modules over an EtherNet/IP network in your CompactLogix 5370 L1 control system, as
described in the Logix5000 Control Systems: POINT I/O over an EtherNet/IP Network Quick Start, publication
IASIMP-QS027 , you must install and configure an EtherNet/IP network.
Completing all of the tasks described in this quick start will assist you when attempting to complete the tasks in
some other quick starts, such as publication IASIMP-QS027.
IMPORTANT The tasks described in this publication use a 1769-L18ERM-BB1B controller.