Rockwell Automation 1769-L16ER-BB1B_L18ER-BB1B_L18ERM-BB1B CompactLogix 5370 L1 Controllers System Quick Start - Manual (Page 51)

Rockwell Automation Publication IASIMP-QS024B-EN-P - December 2012 51
Chapter
4
Create a Logix Designer Project
In this chapter you create a Logix Designer project. In the project you use ladder logic to create a
push button that controls a light on a digital output module.
You learn how to complete the following tasks:
• Create a Logix Designer project.
• Configure your 1769-L18ERM-BB1B controller.
• Add a local expansion module to the project.
• Add ladder logic to the project to test the local expansion module.
• Download the project to the controller.
IMPORTANT You must use Logix Designer application with this quick start. The tasks described in this chapter are described with the
intention that you might reuse the project to complete the tasks described in publications listed on
page 12 .
Because you are likely to use other devices in your CompactLogix 5370 L1 control system, you can use the project created
in this chapter to complete the tasks described in the publications listed on
page 12 .