Configure the controller – Rockwell Automation 1769-L16ER-BB1B_L18ER-BB1B_L18ERM-BB1B CompactLogix 5370 L1 Controllers System Quick Start User Manual
Page 55
Advertising
Rockwell Automation Publication IASIMP-QS024B-EN-P - December 2012
55
Create a Logix Designer Project Chapter 4
5. Set Expansion I/O to a number
that exactly matches the number of
1734 POINT I/O modules
physically installed in the system.
In this case, the value is 1 Module.
6. Click Finish.
Configure the Controller
1. Verify that the mode switch on the
controller is in the REM position.
2. Click the RSWho icon.
RUN
REM
PROG
Advertising