Rockwell Automation 1769-L16ER-BB1B_L18ER-BB1B_L18ERM-BB1B CompactLogix 5370 L1 Controllers System Quick Start - Manual (Page 64)

64 Rockwell Automation Publication IASIMP-QS024B-EN-P - December 2012
Chapter 4 Create a Logix Designer Project
4. Move the mode switch on your
controller to the RUN position.
5. In the Main Routine, select the PB
Examine On instruction.
6. Press Ctrl+T to toggle the state
from 0 to 1, or Off to On.
7. Verify that the status indicator on
the digital output module turns on after you toggle the state to 1 or On.
8. Press Ctrl+T to toggle the state back to 0 or Off.
9. Go Offline.
RUN
REM
PROG