AJA FS1 Version 2.2.0.47 - Manual (Page 21)

1
11 FS1 Installation and Operation Manual — Front Panel
Holding down both the Select buttons at the same time returns the front panel menu to
parameter 1.1 Output Format. If you are editing an octet, string or other
parameter that requires a commit action (like editing a blinking IP address) and
you press both Select buttons, the edit will terminate (will not take effect and will
not be saved). On the other hand, if you are editing menu items that normally
take effect as they are edited (e.g. procamp gain), the edited value will take effect.
Note: Parameter displays and adjustment choices and values are described in detail
in Chapter 4.
Remote Control Pressing the Remote button once results in a display showing how the FS1 is being
controlled. Pressing the button again cycles the display through all control options:
LOCAL+REMOTE: Control is from the panel buttons, a web browser, or remote
panel (VTECS). The Remote button glows white.
REMOTE ONLY: Control of the FS1 is from a web browser on a network attached
computer or a remote control panel via the VTECS protocol (except for the
remote control function). The Remote button glows red.
LOCAL ONLY: FS1 control is only allowed from the front panel buttons (except for
the remote control function). The Remote button glows green.
Indicator
Descriptions Indicators on the front panel are multi-state LEDs that light when a condition is
present. The following indicators are conveniently arranged in groups to show specific
subjects; these LEDs are also discussed on the following pages.
• Activity LEDs
• Power and Status LEDs
Activity Indicators
HD In—Shows that an active HD signal is detected at the previously selected input.
SD In—Shows that an active SD signal is detected at the previously selected input.
HD Out—Shows that an HD signal is being output.
SD Out—Shows that an SD signal is being output.
Aux—This LED is ON whenever a GPI input trigger is active if that GPI affects the
internal state of the FS1. If the associated GPI In parameter (36.1 GPI In 1
Response or 36.2 GPI In 2 Response) is set to No action, the LED stays OFF.
Proc Amp—Shows that the ProcAmp values are different from the factory nominal
values. If lit, the video passing through the FS1 is being altered according to
changes in ProcAmp parameter settings (it’s no longer at unity).
LAN—This LED will flash once whenever the FS1 is being controlled by a web
browser input or remote panel. Web browser actions that do not affect the
internal state of the FS1 will not cause the LED to blink.
Ref—Shows that the FS1 has an external reference video source applied to the Ref
connector.