AJA FS1 Version 2.2.0.47 - Manual (Page 53)

1
43 FS1 Installation and Operation Manual — 4.3 Embed Audio Out
4.3 Embed Audio Out
This parameter allows you to enable or disable audio output. SDI Embedded Audio
output may be On, Muted (embedded silence) or turned Off (no embedded audio).
Analog and AES audio outputs are not affected by 4.3 (they’re left On).
4.4 Sample Rate Convert
This parameter controls audio sample rate conversion on input audio. On is the
default (audio is rate-converted and synced with video) and Off is a setting for use
when Dolby
® 5.1 and similar schemes need to be preserved and the audio data passed
unaltered. Normally, set this to On (default). Set it to Off only if the following are
both true:
1. You want to pass digital encoded audio from either embedded or AES into
embedded and/or AES out.
2. You have the embedded or AES input genlocked to the FS1 output. In other words,
the encoded audio will not survive the frame-sync function (dropping or repeating
frames) so it needs to be set to lock to the input. You can lock to a reference only if
that reference is driving both the FS1 and the upstream source of the embedded or
AES input to the FS1.
Note: If parameter 4.5 Audio Follow Video is set to On, the Sample Rate Convert
selection is independently kept for each separate input: SDI 1, SDI 2, Composite, S-
Video, and Component. If Audio Follow Video is set to Off, another Sample Rate Convert
selection is used.
4.3 Embed Audio Out Description of Choices
Parameter Adjustments:
On ( Default)
Off
Mute
Embedded audio will be passed.
Do not pass embedded audio packets to the SDI outputs.
FS1 outputs SDI embedded audio packets containing silence.
4.4 Sample Rate Conversion Description of Choices
Parameter Adjustments:
On (Default)
Off
Normal operation. The FS1 performs audio sample rate conversion and keeps the
video and audio synchronized.
The FS1 does not sample rate convert the audio, leaving embedded audio as is,
useful for Dolby
¤ 5.1 embedded audio and other applications.