AJA FS1 Version 2.2.0.47 - Manual (Page 61)

1
51 FS1 Installation and Operation Manual — 6.1 Genlock Source
6.1 Genlock Source
This parameter selects the reference video source used for genlocking, either
automatically or explicitly.
6.2 Output Timing H
This parameter adjusts horizontal output timing with reference to the genlock source
already selected. When adjusting the horizontal timing (H), this parameter specifies a
number of pixels to offset, from zero to full line width.
Note: Independent horizontal and vertical timing values are kept for all available
output formats.
6.3 Output Timing V
This parameter adjusts vertical output timing with reference to the genlock source
already selected. When adjusting the vertical timing (V), this parameter specifies a
number of lines to offset, moving the screen up to a half a frame up or down.
6.1 Genlock Source Description of Choices
Parameter Adjustments:
Reference (Default)
Input
Free run
Use the signal on the Ref connector as the genlock source.
Use the signal on the currently selected input as the genlock source.
Free run mode (FS1 syncs to its own timebase, not locked to an external source).
6.2 Output Timing H Description of Choices
Parameter Adjustments:
Variable Adjustment range increments from 0 to the width of the line in pixels. This could be
720, 1280, or 1920, depending on the format already chosen.
Default: 0
6.3 Output Timing V Description of Choices
Parameter Adjustments:
Variable Adjustment range increments from half a frame up to a half a frame down in single
line increments (where the frame size could be 525, 625, 750, or 1125,
depending on the format already chosen).
Default: 0