AJA FS1 Version 2.2.0.47 - Manual (Page 29)

1
1
Chapter 3:
Installation & Configuration
3
Installation Overview
The installation and set up of an FS1 is very simple. Plug both AC supply cords into
AC mains power (separate branch circuits for redundancy), connect the LAN
connector to a LAN, WAN or local computer with a web-browser, and then connect
source and destination video and audio equipment.
Hazard Warning!
High Voltage. This situation or condition can cause injury due to electric shock.
Warning!
Do not open the chassis. There are no user-serviceable parts inside. Opening the chassis
will void the warranty unless performed by an AJA service center or licensed facility.
Warning!
Disconnect the external AC power supply line cord(s) from the mains power before
moving the unit.
Warning!
Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized
plug has two blades with one wider than the other. A grounding type plug has two
blades and a third grounding prong. The wide blade or the third prong are provided for
your safety. If the provided plug does not fit into your outlet, consult an electrician for
replacement of the obsolete outlet.
Warning!
Since the Mains plug is used as the disconnection for the device, it must remain readily
accessible and operable.
Warning!
Protect the power cord from being walked on or pinched
particularly at plugs, convenience receptacles, and the point
where they exit from the device.