Metrohm 863 Compact Autosampler - Manual (Page 22)

3.3 Connecting a computer ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
12 ￭￭￭￭￭￭￭￭ 863 Compact Autosampler
6.2151.110
Figure 5 Connecting the computer
The instrument is recognized. The now following driver installation
varies, depending on the version of the Windows operating system
used.
￭ Either the required driver is installed automatically, or an installa-
tion assistant is started.
3 Follow the instructions of the installation assistant.
If problems should occur during installation, contact your company's IT
supporter.
Registering and configuring the instrument in MagIC Net
The instrument must be registered in the configuration of MagIC Net.
Once that has been done, you can then configure it according to your
requirements. Proceed as follows:
1 Set up the instrument
￭ Start MagIC Net.
The instrument is automatically recognized. The configuration dia-
log for the instrument is displayed.
￭ Make configuration settings for the instrument and its connec-
tors.
More detailed information concerning the configuration of the
instrument can be found in the documentation for the respective PC
software.