Metrohm 815 Robotic Soliprep for LC - Manual (Page 38)

2.15 Mounting the safety shield ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
32 ￭￭￭￭￭￭￭￭ 815 Robotic Soliprep for LC
end of the cable to the COM1 or COM2 port on the PC. The port on
the PC is usually marked with IOIOI. If the PC has no serial interface,
then a USB port on the PC can be used with the aid of an RS232/USB
converter (e.g. the 2.145.0320 Edgeport).
Note
The Polytron must be registered manually in tiamo as an RS232 device.
2.15 Mounting the safety shield
Safety shield 6.2751.150
The 815 Robotic Soliprep for LC may not be operated without a safety shield.
Install it as follows:
1 Mounting the spacer for the safety shield with the screws supplied to
tower 1 according to the following figure.
1
2 Unscrew the black nuts on both sides of tower 1.
3 Pull the green 6.2751.150 safety shield over tower 1, starting from the
top.