Metrohm 815 Robotic Soliprep for LC - Manual (Page 61)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 6 Controlling the Polytron ®
815 Robotic Soliprep for LC ￭￭￭￭￭￭￭￭ 55
￭ Handshake None
￭ Timeout 2000 ms
￭ Terminator for send \0D\0A (= CR LF)
￭ Terminator for receive \0D\0A (= CR LF)
￭ Code page ASCII
6 Click on [Check connection].
In the dialog window of the connection test, you can check the data
transfer to the Polytron by sending a command to the device. A list of
possible commands can be found below, see page 56.
7 Close the window with [OK] and then quit the configuration dialog
with [OK].
Control
The Polytron can be switched off and on with the communications com-
mand TRANSFER. In addition, the rotational speed of the aggregate can
also be set (in revolutions per minute). This can be accomplished when the
Polytron is in either switched-on or switched-off status.
The control commands for the Polytron are comprised of a three-digit
numerical code.
A TRANSFER command for switching on the device could look as follows: